How to install Zevenet an open source load balancing server

you can see the additional components that get loaded for the installation

from next step, you have to configure the network setup. start with assigning your Ipaddress for your server and press continue

Assign a netmask value and press continue

Enter the Gateway address of the server and press continue

Enter the Nameserver addresses but it is optional and press continue

on next screen, you have to Enter the Hostname of your server and then press continue

enter the Domain name of your server and then press continue

setup the root user password. you have to enter the password twice to verify and press continue


after configuring network you have to assign a partition of your server. here we gonna do a manual partitioning so choose manual partition

if you want to utilize full disk space you can choose to use entire disk, the partitioning will be assigned automatically

after choosing the manual partition you will see the following screen where you have to select device for a partition

after choosing the device you have to confirm the device partition by pressing yes

after that you will see the overview of currently configured partition and mount point so choose the free space for assigning new partition and mount point on the selected device

at next step, you have to choose to create a new partition and press enter to proceed further

here we are going to allocate a new partition size from the available free space, after assigning a size, choose to continue

at next step, you have to choose the type of partition you are going to create. choose primary and press enter

now choose where you want to create a partition at the available space so choose “ Beginning” and press enter

at next step, you need to choose the file system of the newly created partition so choose to use as EXT4 file system and select Done setting up partition


next, create a swap partion on the remaining space available at device

follow the same procedure which is used to create a ext file system



Choose the swap file system and select Done setting up the partition


at the end choose Finish Partitioning and write changes to disk to finish the partitioning procedure